Techmatte

Select

Ultra V6 (UV-Gel)

Step #1:
Plug in the UV Light to check if it works properly. Then turn it off.
Step #2:
Turn off your phone and clean the screen with the wet wipe and cleaning cloth.
Step #3:
Use the Screen-Prep Cloth to wipe the phone screen a few times. Then use the Cleaning Cloth to clean the screen again. This helps to prevent the bubbles during application.
Step #4:
Place your phone into the application tray. Make sure to align the top of the phone with the side labeled "TOP." Press firmly into place. Rotate the green Lock Pin to secure the phone.
Step #5:
Insert the Pin into the slot at the end of the application tray. Use the Dust Removal Sticker to clean the screen if there is any dust.
Step #6:
Adjust the application tray to make sure the 2 bubbles are in the center of each bubble level.
Step #7:
Pull off the YELLOW/RED cap of the adhesive tube. Then remove the tip to open the tube.
Step #8:
Hold the tube over the indicated position with the opened end facing down. Unscrew the black cap to release the adhesive from the tube. Please follow the direction of the arrow, and drip the adhesive to the center of the screen.
Step #9:
Peel off the mask film of the screen protector, and set it within the tray, resting one end on your phone screen and the other end on the pin.
Step #10:
SLOWLY pull the pin outward to allow the protector to lower onto the adhesive. Once the protector touches the adhesive puddle, pull the pin out the rest of the way.
Step #11:
The adhesive will begin spreading on its own. While it is spreading, place the metal cylinder on the fingerprint scanner sticker.
Step #12:
Wait for the adhesive to fully spread to all edges of the phone screen. It could take 3-5 minutes. DO NOT TOUCH the screen protector during this time.
Step #13:
Plug in the UV light with your USBC cable. Place the UV light over the tray and device. Cure for about 15 seconds.
Step #14:
Remove metal cylinder and scanner sticker. Rotate the green Lock Pin and remove the phone from the application tray.
Step #15:
Immediately use the UV light again to cure about 60 seconds after step 14 completed.
Step #16:
Re-scan your fingerprints and enjoy the screen protector!

Best Sellers

iPhone 15 Pro

iPhone 15 Pro Max

Galaxy S24

Galaxy S24 Ultra

iPad Mini 6

Nintendo Switch OLED